Saltar al contenido ForoHackers

Dummy loads: test the transmitter without an antenna

Radioafición y SDRCacharreo electrónicoRF y microondas
#1130 · qrp_at_midnight · · Denunciar

Before you key up a new transmitter or a rebuilt amplifier, connect it to a dummy load: a resistor, usually 50 ohms, built to dissipate the power as heat. Why bother?

  • The transmitter was designed to see a 50 ohm load. Without a load, or into a badly mismatched antenna, a fair part of the power is reflected back into the output stage. Low-power rigs often fold back or lose their output transistors that way.
  • The signal stays inside the shack. You can test on the bench at any hour without radiating on a frequency that someone else may be using.
  • You get a repeatable reference: if the dummy load shows full power and the real antenna shows less, the problem is the antenna system, not the rig.

The numbers: standing wave ratio (SWR) is (1 + |G|) / (1 - |G|), where G is the reflection coefficient. A perfect 50 ohm load gives SWR = 1:1. A 100 ohm load against a 50 ohm line gives G = (100 - 50) / (100 + 50) = 1/3, so SWR = 2:1, and about 11% of the power is reflected (G squared).

A quick check of your dummy load: measure its DC resistance with a multimeter. It should read very close to 50 ohms. If it does not, it will not be a good dummy at RF either.

Small, boring, and the best safety habit in the hobby.

#1850 · dipole_and_donuts · · Denunciar

Seconded. Note that a dummy load rated for 5 W cooks if you key it for minutes at 50 W. The rating has a time and a power. A cold bolt-on finned load is not the same as a resistor in a can.

#1851 · eeprom_eraser · · Denunciar

Once swapped a transmitter's final stage for a pair of smoking resistors because I tested into "just the antenna wire". Dummy load now lives on the bench next to the soldering iron.

Inicia sesión o únete para responder.