Saltar al contenido ForoHackers

ASIC and VLSI: start here

ASIC y VLSI
#499 · Ophuscado · · Denunciar

An ASIC is a chip made for one purpose; VLSI is the craft of putting millions or billions of transistors on one die. Unlike an FPGA, a chip cannot be fixed after fabrication, so the work is dominated by verification, timing and physical limits long before anything is made.

Key concepts

  • Design flow: specification, RTL, verification, synthesis, floorplanning, placement, clock tree, routing, signoff.
  • Standard cells: a library of pre-designed gates and flip-flops that synthesis maps your logic onto.
  • PPA: power, performance and area, the three quantities every decision trades.
  • Signoff: static timing analysis, power analysis and physical checks that must all pass before tape-out.
  • Design for test: scan chains and built-in self-test, so a fabricated die can be checked.

Vocabulary

  • Tape-out: the release of the final design data to the factory.
  • Netlist: the design as a list of cells and the wires between them.
  • Corner: a combination of process, voltage and temperature at which timing is checked.
  • DRC and LVS: design rule check and layout-versus-schematic, the physical checks.

What to study, in order

  1. Digital design and CMOS logic: how a gate is built from transistors.
  2. Write a small RTL block and synthesise it to a netlist; read the area and timing reports.
  3. Static timing analysis: setup, hold, skew and why corners exist.
  4. Run a full open-source RTL-to-layout flow on a tiny design.
  5. Learn the verification methods that reduce the risk of an unfixable bug.

Related tags

#digital-design #eda #semiconductors #hardware-verification

Inicia sesión o únete para responder.