Skip to the content ForoHackers
Log inJoin

eeprom_eraser

Joined 1 April 2025

Posts in the forum

  1. Replied in Reading a flash chip in circuit: why the board keeps fighting you

    Good points. Holding in reset needed a pad I had to find with a multimeter, and, yes, the SoC *did* drive the lines for a short moment at power-up. Reading with the supply fed only to the flash worke…

  2. Started Reading a flash chip in circuit: why the board keeps fighting you

    Context: my own old router, in a drawer, and I want a copy of its firmware before I do anything silly. I connected a clip to the SPI flash chip, started a read, and got garbage, different every time.…

  3. Replied in How a pin tumbler lock binds: it is all about tolerances (locksport, own locks only)

    Cutaway-by-hand is the right way to learn it. I did the same with an old mechanical switch from a keyboard: open it, see the leaf spring, understand the click. Understanding first, tricks later.

  4. Replied in Finding a dead short on a board: voltage injection and a steady hand

    For the heat step, a thermal camera is the easy way, but you can also inject a very low voltage, a few hundred millivolts at a higher current limit, so the board stays cool and nothing is stressed, a…

  5. Replied in Milling my own PCBs on a hobby CNC: chip load, and why 0.1 mm bits snap

    For the doubters: yes, you can etch boards chemically too. But a CNC gives you drilled holes and clean edges, and no jar of chemicals on the shelf. Nice numbers, I might steal the chip load formula f…

  6. Replied in Dummy loads: test the transmitter without an antenna

    Once swapped a transmitter's final stage for a pair of smoking resistors because I tested into "just the antenna wire". Dummy load now lives on the bench next to the soldering iron.

  7. Started My quadcopter flipped on takeoff: check motor order and prop direction first

    Tiny quad on my own bench, flight controller I flashed myself. First arming: it leaps, flips over, and lands upside down. I was ready to blame the PID tuning. It was not the PID tuning. On a quad X,…

  8. Replied in The Goertzel algorithm: detecting one tone without a full FFT

    Fixed-point version is easy too if you do not have an FPU: Q15 coefficient and 32-bit accumulators, but watch for overflow on `s1` and `s2` with loud signals. Learned that one by looking at a decoder…

  9. Replied in PID para un horno tostador: el integrador que se vuelve loco (windup)

    In English for the others: yes, clamp the integrator, and ideally stop integrating while the output is saturated (conditional integration). One more thing for relay or SSR control: use a window of a …

  10. Replied in Timing closure is a lifestyle

    Clock domain crossings are where my bricked boards go to be mysterious. A synchroniser I forgot, and the thing works for ten minutes and then does not. I will be reading everything you post.

  11. Replied in Bricked it again

    First recovery will be a classic: a chip set to an external clock source that did not exist. It woke up as soon as I fed it a clock pulse from a spare board. Photos, fuse values and the one wire I fo…

  12. Started Bricked it again

    I flash firmware onto small boards and, as my handle suggests, sometimes onto the wrong things. I have bricked more microcontrollers than I have fingers, and each one taught me something about fuse b…