Skip to the content ForoHackers
Log inJoin

solder_smoke_sniffer

Joined 28 September 2024

Posts in the forum

  1. Replied in Reading a flash chip in circuit: why the board keeps fighting you

    On the "other parts leak through their pins" point: it is called back-powering, and it is real. A 100-ohm series resistor in the supply line while you measure can show you how much current is sneakin…

  2. Replied in How a pin tumbler lock binds: it is all about tolerances (locksport, own locks only)

    Tolerance stack-up as a feature: same reason a batch of resistors "5 %" are not all off by exactly 5 %. Manufacturing noise is a resource if you know where to look, and a vulnerability if you assume …

  3. Replied in Finding a dead short on a board: voltage injection and a steady hand

    Tantalum warning is gold. And for anyone doing this the first time: write down what you remove, in order. I have an extensive collection of "I will remember this" parts in a tray that I remember noth…

  4. Started Finding a dead short on a board: voltage injection and a steady hand

    A dead board with a short between the 3.3 V rail and ground. The multimeter in continuity mode beeps everywhere, which tells you nothing. Here is the method that has saved me more boards than staring…

  5. Replied in Hola: soluciones caseras que funcionan (y que no enseñaría a mi madre)

    One tip from the repair bench: if the duct-tape fix touches mains voltage or a power supply's insides, stop and do it properly. Everything below that, a clever hack is a legitimate engineering tradit…

  6. Replied in Humedad del suelo en el huerto: por qué los sensores resistivos se pudren

    Besides varnish, check that the board edges are not exposed copper. Many capacitive boards have a fine trace at the edge that wicks water. A drop of conformal coating, or even nail varnish, on the ex…

  7. Started Milling my own PCBs on a hobby CNC: chip load, and why 0.1 mm bits snap

    I have a small desktop CNC that I use to isolation-route simple PCBs (my own designs, for my own projects). The first week I snapped nine 0.1 mm V-bits. Here is the maths that stopped me wasting more…

  8. Replied in How I lost three days fixing a first layer

    Also check that the bed thermistor and the heater are well attached. A bed that reads the right temperature at one spot and is ten degrees off elsewhere will make the mesh lie to you. A simple IR the…

  9. Replied in Reprinting a snapped plastic gear for an old drive, and what material survives

    If the gear is under real load, consider printing a test copy at 100% infill first and putting it in the mechanism with the case open. And annealing PETG or nylon after printing makes them tougher at…

  10. Replied in PID para un horno tostador: el integrador que se vuelve loco (windup)

    One more thing about thermocouples: the amplifier chip does cold-junction compensation, so it must sit at the same temperature as the connector where the thermocouple wire ends. If it sits near the h…

  11. Replied in No dependas solo del color: un indicador con LEDs para todo el mundo

    For the blink patterns, be careful with fast flashing: a very fast, bright flicker can be unpleasant or worse for people sensitive to it. Keep it to a couple of hertz at most. And a small piezo beepe…

  12. Started Cold joints: how to tell and how to stop making them

    Hi all. I fix electronics for fun and from stubbornness, and the number one cause of "it worked yesterday" on old boards is a cold or cracked solder joint. How to spot one: dull, grainy or lumpy sur…