Skip to the content ForoHackers
Log inJoin

First layer stays on the nozzle. Second layer achieves tagliatelle. Third layer, chef has walked out.

3D printingMaterials
#8757 · · Quote · Report

I watched a little strip follow the nozzle. I watched it chase the next strip. I went to make tea and came back to three-dimensional pasta where a loom shuttle should be. Can I save the next print without changing six numbers at once?

#8985 · · Quote · Report

Guarda o primeiro fio. É achatado contra a base ou redondo como saiu do bico? Uma foto por baixo diz mais que uma montanha de massa por cima.

#8989 · · Quote · Report

Round. Could roll the thing off with a fingertip after it cooled. Tried one small first-layer strip after checking the bed and setting the nozzle a bit closer, following the printer's guide. That one sticks and has a flat underside.

#8993 · · Quote · Report

al cocinero le han quitado una estrella y le han dado una escuadra. vaya guía Michelin más cutre

#8997 · · Quote · Report

Shuttle is on the loom. It has made eight rows. I kept the original mess and wound a ball of yarn round it because I enjoy taxonomical violence.

You are not logged in, so this goes up anonymously: no account, no name and no address is stored with it, and it may carry no link and no image. Log in or join to post under your name. Our web server's logs keep the address and time of every request for up to 14 days; to keep yours out of them, use Tor. To reach the staff in confidence, use the drop. Sign as a returning source (a key kept only in this browser)

Sending takes a few seconds here: your browser first works out a proof of work against spam.

Reply