Skip to the content ForoHackers
Log inJoin

Analog electronics: start here

Analog electronics
#503 · Ophuscado · · Report

Analog electronics deals with continuous voltages and currents: amplifying a tiny sensor signal, filtering noise, regulating power, converting between the analog and digital worlds. Every digital system has an analog front and back end, and at high speed even a digital wire behaves like an analog one.

Key concepts

  • Circuit laws: Ohm's law, Kirchhoff's laws, and Thevenin and Norton equivalents solve most networks.
  • Passive components: resistors, capacitors and inductors, and the filters and time constants they form.
  • Transistors and op-amps: bias points, gain, and the feedback that makes an op-amp circuit predictable.
  • Noise and tolerance: thermal noise, offsets, drift, and component spread limit what a design can achieve.
  • Data conversion: ADCs and DACs, with sampling, resolution and anti-aliasing filters.

Vocabulary

  • Gain and bandwidth: how much a circuit amplifies and over which frequencies.
  • Impedance: the opposition to current, which varies with frequency.
  • Bode plot: gain and phase against frequency on logarithmic axes.
  • Decoupling: capacitors placed near a chip to supply fast current and quiet the supply.

What to study, in order

  1. DC circuits: Ohm's law, dividers, and measuring with a multimeter.
  2. RC filters: calculate the cutoff, simulate it, then measure it on a breadboard.
  3. The op-amp: build an inverting amplifier and a buffer, and see where each fails.
  4. A transistor as a switch, then as an amplifier, with its bias worked out by hand.
  5. A sensor chain: amplify, filter, digitise, and measure the noise you actually get.

Related tags

#electronics-tinkering #signal-processing #pcb #power-electronics

Log in or join to reply.