Skip to the content ForoHackers
Log inJoin

Electronics tinkering: start here

Electronics tinkering
#613 · Ophuscado · · Report

Electronics tinkering is building circuits for fun and learning: blinking LEDs, reading sensors, driving motors, making a small gadget. With a breadboard, a few components and a microcontroller board you can go from idea to working prototype in an evening, and you learn by measuring what the circuit actually does, not what you hoped it would do.

Key concepts

  • Ohm's law: voltage, current and resistance are tied together; it sizes the resistor that keeps an LED alive.
  • Microcontroller boards: a programmable board that reads inputs and drives outputs, so one circuit can do many jobs.
  • Measuring: start with a multimeter; an oscilloscope shows how signals change in time.
  • Safety: stay with low voltage and never work on mains-powered circuits; charge and store lithium cells with proper chargers; solder in a ventilated place and protect your eyes.

Vocabulary

  • Breadboard: a board of connected sockets for building circuits without solder.
  • Pull-up resistor: a resistor that holds an input at a known level when nothing drives it.
  • Datasheet: the maker's document with a part's limits, pinout and typical circuits.
  • Decoupling capacitor: a small capacitor beside a chip that smooths its supply.

What to study, in order

  1. Learn voltage, current and resistance; light an LED with the right resistor and check it with a multimeter.
  2. Use a transistor as a switch and read a button with a pull-up resistor.
  3. Program a microcontroller board to read a sensor and print its values.
  4. Drive a motor or a relay safely, with a proper driver and a diode across the load.
  5. Practise soldering on scrap boards before your first real project.

Related tags

#microcontrollers #analog #pcb #digital-design #diy

Log in or join to reply.