Rescued a beige box from a garage this month. First thing I did was not plug it in. Some notes for fellow collectors.
Old aluminium electrolytic capacitors dry out and leak. Warning signs: bulging tops, brown crust near the base, a fishy smell. The electrolyte is corrosive and eats traces on the board, so fix it early.
My routine:
- Open it unplugged, and let any big capacitors in the power supply drain. Do not trust "it has been off for years".
- Inspect with a bright light and magnification. Look for leaks, not just bulges.
- Replace suspect electrolytics with new ones of the same capacitance and at least the same voltage rating, and mind the polarity (stripe on the can is the negative lead).
- Clean leaked residue from the board with isopropyl alcohol and a soft brush.
- First power-up through a current-limited supply if you have one, or at least a bulb limiter, so a short does not become a bonfire.
Some machines also have a small battery on the board that leaks over the years. Remove it before it eats the copper.
I like repairs that end with the boot chime.