solder_smoke_sniffer
Se unió el 28 septiembre 2024
Mensajes en el foro
-
Respondió en Reading a flash chip in circuit: why the board keeps fighting you
On the "other parts leak through their pins" point: it is called back-powering, and it is real. A 100-ohm series resistor in the supply line while you measure can show you how much current is sneakin…
-
Respondió en How a pin tumbler lock binds: it is all about tolerances (locksport, own locks only)
Tolerance stack-up as a feature: same reason a batch of resistors "5 %" are not all off by exactly 5 %. Manufacturing noise is a resource if you know where to look, and a vulnerability if you assume …
-
Respondió en Finding a dead short on a board: voltage injection and a steady hand
Tantalum warning is gold. And for anyone doing this the first time: write down what you remove, in order. I have an extensive collection of "I will remember this" parts in a tray that I remember noth…
-
Inició Finding a dead short on a board: voltage injection and a steady hand
A dead board with a short between the 3.3 V rail and ground. The multimeter in continuity mode beeps everywhere, which tells you nothing. Here is the method that has saved me more boards than staring…
-
Respondió en Hola: soluciones caseras que funcionan (y que no enseñaría a mi madre)
One tip from the repair bench: if the duct-tape fix touches mains voltage or a power supply's insides, stop and do it properly. Everything below that, a clever hack is a legitimate engineering tradit…
-
Respondió en Humedad del suelo en el huerto: por qué los sensores resistivos se pudren
Besides varnish, check that the board edges are not exposed copper. Many capacitive boards have a fine trace at the edge that wicks water. A drop of conformal coating, or even nail varnish, on the ex…
-
Inició Milling my own PCBs on a hobby CNC: chip load, and why 0.1 mm bits snap
I have a small desktop CNC that I use to isolation-route simple PCBs (my own designs, for my own projects). The first week I snapped nine 0.1 mm V-bits. Here is the maths that stopped me wasting more…
-
Respondió en How I lost three days fixing a first layer
Also check that the bed thermistor and the heater are well attached. A bed that reads the right temperature at one spot and is ten degrees off elsewhere will make the mesh lie to you. A simple IR the…
-
Respondió en Reprinting a snapped plastic gear for an old drive, and what material survives
If the gear is under real load, consider printing a test copy at 100% infill first and putting it in the mechanism with the case open. And annealing PETG or nylon after printing makes them tougher at…
-
Respondió en PID para un horno tostador: el integrador que se vuelve loco (windup)
One more thing about thermocouples: the amplifier chip does cold-junction compensation, so it must sit at the same temperature as the connector where the thermocouple wire ends. If it sits near the h…
-
Respondió en No dependas solo del color: un indicador con LEDs para todo el mundo
For the blink patterns, be careful with fast flashing: a very fast, bright flicker can be unpleasant or worse for people sensitive to it. Keep it to a couple of hertz at most. And a small piezo beepe…
-
Inició Cold joints: how to tell and how to stop making them
Hi all. I fix electronics for fun and from stubbornness, and the number one cause of "it worked yesterday" on old boards is a cold or cracked solder joint. How to spot one: dull, grainy or lumpy sur…