An ASIC is a chip made for one purpose; VLSI is the craft of putting millions or billions of transistors on one die. Unlike an FPGA, a chip cannot be fixed after fabrication, so the work is dominated by verification, timing and physical limits long before anything is made.
Key concepts
- Design flow: specification, RTL, verification, synthesis, floorplanning, placement, clock tree, routing, signoff.
- Standard cells: a library of pre-designed gates and flip-flops that synthesis maps your logic onto.
- PPA: power, performance and area, the three quantities every decision trades.
- Signoff: static timing analysis, power analysis and physical checks that must all pass before tape-out.
- Design for test: scan chains and built-in self-test, so a fabricated die can be checked.
Vocabulary
- Tape-out: the release of the final design data to the factory.
- Netlist: the design as a list of cells and the wires between them.
- Corner: a combination of process, voltage and temperature at which timing is checked.
- DRC and LVS: design rule check and layout-versus-schematic, the physical checks.
What to study, in order
- Digital design and CMOS logic: how a gate is built from transistors.
- Write a small RTL block and synthesise it to a netlist; read the area and timing reports.
- Static timing analysis: setup, hold, skew and why corners exist.
- Run a full open-source RTL-to-layout flow on a tiny design.
- Learn the verification methods that reduce the risk of an unfixable bug.