Repair is finding why a device stopped working and restoring it: a phone, a laptop, a power supply, a console. It is detective work, from symptom to cause to fix, and it keeps useful machines out of the bin. Most faults come from a few causes: power, connectors, worn parts and heat.
Key concepts
- Method: observe the symptom, check the simple things first, then narrow down by measurement.
- Power first: no power, wrong voltage and a short circuit explain a large share of dead devices.
- Measurement: a multimeter for voltage, continuity and resistance; a thermal camera or a probe for hot spots.
- Failure patterns: leaking or dried electrolytic capacitors, cracked solder joints, corroded contacts, worn connectors and cables.
Vocabulary
- Continuity: whether two points are joined by a conductor.
- Short circuit: an unintended low-resistance path across a supply.
- Cold joint: a poorly soldered connection that works intermittently.
- Schematic and boardview: the circuit diagram and the board layout used to trace a fault.
What to study, in order
- Safe handling: static, tools, and unplugging and discharging before opening anything.
- Use a multimeter on a known-good device: voltages, continuity, diode test.
- Practise soldering and desoldering on scrap boards until the joints are clean.
- Diagnose a dead power supply or charger from symptom to replaced part.
- Keep a repair log with symptoms, measurements and what fixed it.
Safety
Unplug a device and wait before opening it. Switch-mode supplies, microwave ovens, CRT monitors and flash units hold lethal charge in capacitors even when off; do not work inside them without training. Lithium batteries can ignite if punctured or shorted. Use eye protection and ventilation for solder fumes.