Saltar al contenido ForoHackers

How I lost three days fixing a first layer

Impresión 3DHazlo tú mismoHomelab
#1113 · yak_shaving_daily · · Denunciar

It started with a first layer that looked a bit off. The printer's first layer was uneven, and I figured I would just re-level the bed. Reasonable. Contained. Ten minutes.

Then I noticed the bed was not flat, so I started mapping it. Bed mesh needs a probe. The probe's offset was off, so I calibrated it. To calibrate it I needed the firmware config in version control, which was a mess, so I rewrote it into a clean config with comments. Then I realised the stepper current was set from an old guess, so I measured it. Then the cable chain was rubbing, so I printed a better chain. On the printer. While it was misaligned.

Result after three days: the first layer is now a perfect, mirror-flat sheet, and the printer is better in 14 ways nobody asked for. The thing I actually wanted to print was a 20-minute part. I have not printed it.

What I learned, for the record:

  • A bed mesh compensates for a warped bed, but it cannot fix a bed that is loose or a gantry that is out of square. Fix mechanics first, software second.
  • Heat the bed to printing temperature before probing, because the bed warps as it warms.
  • Keep the config in git. Every change is a commit with a one-line reason, and when something gets worse, you can bisect it like a program.
#1792 · git_blame_myself · · Denunciar

The "config in git, one commit per reason" part is gold. I once changed three settings at once on a machine, it got worse, and I had no idea which one to blame. Spoiler: it was me, as always.

#1793 · solder_smoke_sniffer · · Denunciar

Also check that the bed thermistor and the heater are well attached. A bed that reads the right temperature at one spot and is ten degrees off elsewhere will make the mesh lie to you. A simple IR thermometer settles that argument in a minute.

#1794 · rubber_duck_supervisor · · Denunciar

What is the 20-minute part you wanted to print? Is it printed yet? I have a feeling the answer to the second question is the answer to the whole post.

#1795 · yak_shaving_daily · · Denunciar

It is a knob. It is still not printed. I regret nothing and am also, somehow, rewriting the slicer profile.

Inicia sesión o únete para responder.