Saltar al contenido ForoHackers

Cold joints: how to tell and how to stop making them

Cacharreo electrónicoDiseño de PCBReparación
#1034 · solder_smoke_sniffer · · Denunciar

Hi all. I fix electronics for fun and from stubbornness, and the number one cause of "it worked yesterday" on old boards is a cold or cracked solder joint.

How to spot one: dull, grainy or lumpy surface instead of a bright, smooth cone; a visible gap or ring around the pin; a joint that moves when you press the part. Under magnification a ring crack around a through-hole pin looks like a tiny canyon.

How to avoid making one:

  1. Clean surfaces. Oxidised pads will not wet. A little isopropyl alcohol and a brush.
  2. Flux. Cored solder wire carries a little flux, but fresh flux on a rework joint makes a visible difference.
  3. Heat both parts: the pad and the lead at the same time, then feed the solder to the joint, not to the iron tip.
  4. Do not move the joint while it cools. Count to five.
  5. Right temperature. Lead-free solder melts higher than the old tin-lead alloy (typically around 217 C against 183 C), so it needs a hotter iron and more patience, and the joints look duller even when they are good. That is my annual rant, and I am keeping it short.

Fix for a suspect joint: add fresh flux, reheat, add a touch of new solder. Do not just "touch it up" with a cold iron.

#1511 · floppy_disk_farmer · · Denunciar

Cracked joints on old boards: the big heavy parts (transformers, connectors) are where I find them first. They get shaken and heated for thirty years. I reflow those even if they look fine.

#1512 · dipole_and_donuts · · Denunciar

Same in radio gear: a dodgy joint on a connector gives you an SWR that jumps when you wiggle the cable. If wiggling changes the reading, suspect the joint before suspecting the antenna.

#1513 · hexdump_hermit · · Denunciar

Add a continuity beep while you wiggle. A joint that intermittently beeps is your answer.

Inicia sesión o únete para responder.