Saltar al contenido ForoHackers

Milling my own PCBs on a hobby CNC: chip load, and why 0.1 mm bits snap

CNC y mecanizadoHazlo tú mismoDiseño de PCB
#1135 · solder_smoke_sniffer · · Denunciar

I have a small desktop CNC that I use to isolation-route simple PCBs (my own designs, for my own projects). The first week I snapped nine 0.1 mm V-bits. Here is the maths that stopped me wasting more.

Chip load is how much material each cutting edge removes per revolution:

chip_load = feed_rate / (spindle_rpm x number_of_flutes)

Example: 2 flutes, 20000 rpm, feed 300 mm/min:

300 / (20000 x 2) = 0.0075 mm per tooth

Too low a chip load and the tool rubs instead of cutting: it heats up, dulls, and deflects. Too high and a thin bit simply breaks. For tiny bits the safe window is narrow.

What fixed my breakages:

  1. Spoilboard and bed flatness. If the board is 0.05 mm higher at one corner, the bit plunges too deep there. I surfaced the spoilboard and probed the board surface with a height map before routing.
  2. Depth of cut. Isolation routing needs 0.05 to 0.08 mm, not 0.2. The V-bit's effective width grows with depth, so depth sets your track clearance too.
  3. Runout. A wobbling spindle makes one flute do all the work. Check it with a dial indicator or at least by eye with a magnifier.
  4. Dust. Fibreglass dust is nasty stuff: dust shoe, vacuum, eye protection, and a mask when cleaning up.
  5. Feed that is gentle on the first test. Slow down for plunges, then ramp up.

Now a board takes 25 minutes and the bit lasts a dozen boards. Tracks are 0.2 mm wide with 0.2 mm gaps and pass the continuity check.

#1867 · floppy_disk_farmer · · Denunciar

The height-map step is the one nobody wants to do and everybody needs. I do the same when milling front panels. Also, the vacuum saves your lungs and your electronics, fibreglass dust gets in everything.

#1868 · eeprom_eraser · · Denunciar

For the doubters: yes, you can etch boards chemically too. But a CNC gives you drilled holes and clean edges, and no jar of chemicals on the shelf. Nice numbers, I might steal the chip load formula for my own router.

#1869 · yak_shaving_daily · · Denunciar

I now want to build a CNC to mill a PCB that controls a CNC. I will report back eventually.

#1870 · dipole_and_donuts · · Denunciar

For anyone cutting copper clad: vacuum the board and the bed before you power up anything, and keep the board dry and free of conductive swarf before you power up anything. Metal dust is not shy.

Inicia sesión o únete para responder.