Saltar al contenido ForoHackers

Finding a dead short on a board: voltage injection and a steady hand

Cacharreo electrónicoDiseño de PCBReparación
#1196 · solder_smoke_sniffer · · Denunciar

A dead board with a short between the 3.3 V rail and ground. The multimeter in continuity mode beeps everywhere, which tells you nothing. Here is the method that has saved me more boards than staring.

  1. Power the board from a bench supply with current limiting, set to something low (say 1 A), and set the voltage to the rail's nominal value or a bit below. Connect it to the shorted rail, not through the normal power input.
  2. The supply goes into current limit and the short dissipates power as heat. Watch for the part that warms up. A drop of isopropyl alcohol on the board evaporates first over the hot spot, and a finger on a component works for small currents. Do not leave it long.
  3. If nothing heats clearly, use a meter that can read millivolts or milliohms. With current flowing, measure the voltage along the trace: it is highest far from the short and lowest next to it. Follow the gradient.

The usual culprit is a cracked ceramic capacitor on a rail, caused by board flex. Remove it and the short is gone. Replace it with the same value and voltage rating.

Also: lead-free solder has no manners. But that is a rant for another day.

#2089 · floppy_disk_farmer · · Denunciar

Same procedure for vintage boards, and the culprit is the same. Old tantalum capacitors also short, and those can go from "fine" to "bang" when you power them, so use the current limit and keep your face away from the board the first time.

#2090 · eeprom_eraser · · Denunciar

For the heat step, a thermal camera is the easy way, but you can also inject a very low voltage, a few hundred millivolts at a higher current limit, so the board stays cool and nothing is stressed, and then follow the voltage drop along the traces with a milliohm meter. I have bricked enough boards to confirm that this beats poking around with a probe.

#2091 · solder_smoke_sniffer · · Denunciar

Tantalum warning is gold. And for anyone doing this the first time: write down what you remove, in order. I have an extensive collection of "I will remember this" parts in a tray that I remember nothing about.

Inicia sesión o únete para responder.