dipole_and_donuts
Se unió el 24 septiembre 2024
Mensajes en el foro
-
Respondió en My dipole sounded better after I put a choke on the coax
A second one at the entry point is on my list. A neat test: with the rig on a dummy load, run a short piece of wire near the coax and listen for that noise on receive. If it goes away with the choke,…
-
Inició My dipole sounded better after I put a choke on the coax
A small experiment from the weekend, for anyone with a wire dipole and a long coax run. A dipole is balanced, coax is not. Without something at the feed point to keep them apart, part of the RF curr…
-
Respondió en Milling my own PCBs on a hobby CNC: chip load, and why 0.1 mm bits snap
For anyone cutting copper clad: vacuum the board and the bed before you power up anything, and keep the board dry and free of conductive swarf before you power up anything. Metal dust is not shy.
-
Respondió en Mi wifi iba lento y la culpa era del canal (y de mi vecino, que no tiene la culpa)
Good summary. One more thing for the antenna-minded: before changing channels, try just moving or reorienting the access point. A router on the floor behind a metal cabinet loses more than a bad chan…
-
Respondió en Dummy loads: test the transmitter without an antenna
Seconded. Note that a dummy load rated for 5 W cooks if you key it for minutes at 50 W. The rating has a time and a power. A cold bolt-on finned load is not the same as a resistor in a can.
-
Respondió en Decodificando a mano el sensor de temperatura de mi balcón (OOK a 433 MHz)
Listening-only is the sensible default. As a licensed ham I will add that the 433 MHz ISM band has strict power and duty-cycle limits for unlicensed devices, and that is the kind of thing worth readi…
-
Respondió en The Goertzel algorithm: detecting one tone without a full FFT
For CW I do exactly this. Envelope of the Goertzel output over time, threshold, then measure dit and dah lengths. The only problem is QSB: the tone fades and your threshold must follow. Adaptive thre…
-
Respondió en Low power, late hours
Welcome to the quiet end of the spectrum. Narrow filter, good ground, and a dipole that is actually resonant will take you further than a lot of wattage. Looking forward to your antenna stories.
-
Respondió en Cold joints: how to tell and how to stop making them
Same in radio gear: a dodgy joint on a connector gives you an SWR that jumps when you wiggle the cable. If wiggling changes the reading, suspect the joint before suspecting the antenna.
-
Respondió en Cutting a half-wave dipole for 40 m, the maths and the reality
Fishing pole masts are a classic. Light, tall, cheap, and no one asks questions. Just stay clear of power lines when raising it. That one is not negotiable.
-
Inició Cutting a half-wave dipole for 40 m, the maths and the reality
Hello all, licensed ham here, with a donut in hand. Let me share the formula I use before I go up a ladder. A half-wave dipole is two quarter-wave wires, one on each side of the feed point. In free …