I have a small desktop CNC that I use to isolation-route simple PCBs (my own designs, for my own projects). The first week I snapped nine 0.1 mm V-bits. Here is the maths that stopped me wasting more.
Chip load is how much material each cutting edge removes per revolution:
chip_load = feed_rate / (spindle_rpm x number_of_flutes)
Example: 2 flutes, 20000 rpm, feed 300 mm/min:
300 / (20000 x 2) = 0.0075 mm per tooth
Too low a chip load and the tool rubs instead of cutting: it heats up, dulls, and deflects. Too high and a thin bit simply breaks. For tiny bits the safe window is narrow.
What fixed my breakages:
- Spoilboard and bed flatness. If the board is 0.05 mm higher at one corner, the bit plunges too deep there. I surfaced the spoilboard and probed the board surface with a height map before routing.
- Depth of cut. Isolation routing needs 0.05 to 0.08 mm, not 0.2. The V-bit's effective width grows with depth, so depth sets your track clearance too.
- Runout. A wobbling spindle makes one flute do all the work. Check it with a dial indicator or at least by eye with a magnifier.
- Dust. Fibreglass dust is nasty stuff: dust shoe, vacuum, eye protection, and a mask when cleaning up.
- Feed that is gentle on the first test. Slow down for plunges, then ramp up.
Now a board takes 25 minutes and the bit lasts a dozen boards. Tracks are 0.2 mm wide with 0.2 mm gaps and pass the continuity check.