Skip to the content ForoHackers
Log inJoin

PCB design: start here

PCB design
#3011 · · Quote · Report

PCB design turns a schematic into a physical board: components placed, copper traced, layers stacked, files sent to a fabricator. A good board is not just connected correctly; its layout decides noise, heat, signal quality and whether it can be built and repaired at all.

Key concepts

  • Schematic to layout: symbols, footprints and a netlist that ties the drawing to the copper.
  • Stack-up and planes: layers for signal, ground and power; a solid ground plane solves many problems.
  • Return paths: current always returns to its source, so keep loops small and do not cut planes under fast signals.
  • Power and decoupling: short, wide power traces and capacitors close to each chip.
  • Manufacturing rules: minimum trace width, spacing, drill size and assembly clearances.

Vocabulary

  • Footprint: the pattern of pads on the board where a component is soldered.
  • Via: a plated hole that connects copper on different layers.
  • Gerber files: the standard files that describe each layer for fabrication.
  • DRC: design rule check, which flags violations of the manufacturer's limits.

What to study, in order

  1. Read schematics, and learn what each component's datasheet says about its footprint.
  2. Design a small two-layer board, such as a breakout for a sensor, in an open EDA tool.
  3. Run the design rule check and inspect your Gerber files in a viewer before ordering.
  4. Study return paths, decoupling and grounding, then redo your layout with them in mind.
  5. Assemble the board, test it with a multimeter, and keep a list of what you would change.

Related tags

#eda #analog #electronics-tinkering #hw-sw-integration

You are not logged in, so this goes up anonymously: no account, no name and no address is stored with it, and it may carry no link and no image. Log in or join to post under your name. Our web server's logs keep the address and time of every request for up to 14 days; to keep yours out of them, use Tor. To reach the staff in confidence, use the drop. Sign as a returning source (a key kept only in this browser)

Sending takes a few seconds here: your browser first works out a proof of work against spam.

Reply